Best answer: How do I adjust my Overlocker?

How do you adjust the width of a serger?

If the overlock uses two needles, the stitch width can be adjusted by removing one of the needles. This can be done only when a three–thread stitch is used. The stitch length of an overlock machine may vary from 0 to 5 mm (0–0.2 inch). The stitch can be adjusted by turning a dial, moving a lever, or loosening a screw.

Why is my serger bunching up?

If the upper looper thread loops are visible on the wrong side, they’re either too loose or the lower looper thread is pulling them too tight. So you can either turn the lower looper tension dial down or turn the upper looper tension dial up.

How do I make my Overlocker smaller?

How to create a narrow overlock stitch

  1. Turn off the machine and unplug the power cord.
  2. Remove the left needle.
  3. Thread the machine for a three thread overlock using the right needle. …
  4. Remove the stitch finger. …
  5. Adjust the stitch width for rolled hemming. …
  6. Set the stitch length adjustment lever to R position.

Can you straight stitch with a serger?

The straight stitch is widely used in most sewing projects. A serger doesn‘t have a bobbin. It has a different number of loopers to create the seams. It seals the edges of the cloth pieces or joins them together.

IT IS INTERESTING:  How do you count rows in stockinette stitch?

Can you use a serger with one needle?

– On serger stitches with one only needle, choose which one you’re going to use considering your thread’s and fabric’s thickness: use the left one with thicker and the right one for lighter ones.

Why does my thread bunch up on the bottom?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.